Yamaha Forums banner

1 - 1 of 1 Posts

4 Posts
Discussion Starter #1
Evening all, I thought I'd have a go at oil seals on my ybr suspension, everything was going smoothly until taking the seal out.

It was in poor shape and now it's even worse. Load of rubber stripped off it, seal puller and slide hammer couldn't grip it, even torched it there with a weed burner in case it was glued in and it would loosen it up, did it hell.

Anyway this is what I'm left with (See pic) and I'm bloody frustrated with it, any ideas, suggestions, comments would be welcome, should I just bite the bullet and take it down to the mechanics?

1 - 1 of 1 Posts